Log In     My Account       Your cart is empty.     SKYPE

Currencies:
     English  French  


Home >>  RF Accessories >>  Receiver Modules >>  12 Channels Low Level Output Super Regeneration - RF Wireless Receiver Module With Decoder

Stay In Touch

12 Channels Low Level Output Super Regeneration - RF Wireless Receiver Module With Decoder


Price: US $18.00

Add to Cart:    Write Review

  • Model: 0020244

Please Choose:









 
 
Manual

Feature:

  • Model No.: 0020244
  • Type: Receiver module with decode for fixed code
  • Modulation Method: Amplitude modulation (ASK or OOK)
  • Working Voltage: DC 9 ~ 12V
  • Working Current: 5~8mA
  • RF Sensitivity: -103dBm
  • Coding Method: Learning fixed code
  • Decoding Outputs: Low level
  • Working Temperature: -20°C ~ +70°C
  • Size: 40x39x17mm
  • With 12 decoding outputs
  • Control Modes: Toggle, Momentary, Latched
  • Frequency: We can offer 315 MHz or 433.92 MHz, you can choose one.

Application:

  • The RF receiver modules are widely used for remote controls, remote control toys, anti-theft alarms, garage doors, roller shutter, road barrier, retractable doors and so on.

Notes:

  • It is best to use the antenna of 1/4 wavelength, for antenna has a great impact on receiving effect of the module; normally using 50Ω single core cable. For frequency 315MHz, the length of antenna is about 23cm; for 433MHz, it is about 17cm. The position of antenna also affects the receiving effect of the module. When installing the antenna should be extended as much as possible and be away from the shield and the place in high pressure and interference.
  • The receiving frequency, decoding mode and timing resister should be compatible with the transmitter.

Learning methods and steps for 3 control models:

  • Press and hold the button of receiver, then release the button when LED flashes once, it means the receiver is in the status of LEARNING.
  • Press any button of 1, 2, 4, 8 of remote control in 10 seconds, if LED flashes quickly and then off, it means LEARNING is successful. If LED flashes once after 10 seconds, it means LEARNING is failed and the receiver will quit the status of learning.
  • The receiver can learn several remote controls of different codes.

Setting different control modes:

  • Learning method of control mode Latched: When the receiver is in the status of LEARNING, press button 1 of the remote control.
    Control mode Latched (output 1~12): Press -> On, other outputs Off; Press other button -> Off.
    Outputs 1~4 are interlocked; Outputs 5~8 are interlocked; Outputs 9~12 are interlocked.
  • Learning method of control mode Momentary: When the receiver in the status of LEARNING, press button 2 or 8 of the remote control.
    Control mode Momentary (output 1~12): Press and hold -> On; Release -> Off.
  • Learning method of control mode Toggle: When the receiver is in the status of LEARNING, press button 4 of the remote control.
    Control mode Toggle (output 1~12): Press -> On; Press again -> Off.

Introduction of pin (from left to right)

PinsFunction
D0~D11Data output
VCCPositive power supply
GNDNegative power supply

Ask A Question
* Required information

*
*
rmmg
*