Working Voltage Range of Relay: AC110~240V or DC0~28V
PCB size: 67mm x 50mm x 18mm
Case size: 75mm x 54mm x 27mm
Static Current: ≤6mA
Maximum Working Current: 10A
The receiver can pair different model transmitters with one button, includes:C-1、CWB-1、CP-1、CB-1
External Extend Antenna:
Frequency Range: 300~450MHz
Antenna Length: 15cm
Cable Length: 150cm
Anti-interference, waterproof, shielded wire set inside
Magnetic stand design for easy to install
Initial state: A, B = Normally Closed; B, C = Normally Open. 1) Press button: Turn on relay (connect B and C, disconnect A and B) 2) Press button again: Turn off relay (disconnect B and C, connect A and B)
We have learned remote control to the receiver. If you don’t want the receiver to work with the remote control, you can delete all codes of remote controls, which are stored in the receiver. Operation: Press and hold the button of receiver until signal LED flashes slowly; release the button, LED keeps slow flash. That means all stored codes have been deleted successfully.
Learning the button of remote control:
1) Press the button of receiver; signal LED on the receiver keeps shining. The receiver enters into status of LEARNING.
2) Press any one button on remote control. If signal LED flashes quickly 15 times and turns off, it means learning is successful.
3) When receiver is in the status of LEARNING, press again the button of receiver, signal LED turns off, learning process will be discontinued.
4) The receiver can learn several remote controls with different codes.
1 x Receiver: S1T-DC06-ANT2 / S1T-DC09-ANT2 / S1T-DC12-ANT2 / S1T-DC24-ANT2 (1 Channel / Toggle Control Mode)