This 1 channel 30A long range remote control operates in toggle, momentary and latched mode (set the mode as you like freely). It can be used to control lights, motors, electrically operated doors / locks / windows / blinds / cars or other appliances with AC110~240V or DC0~28V. With external extend antenna, the transmitter and receiver have longer working range, up to 2000M.
Control Lights, Motors, Fans, electrically operated Doors/Locks/Windows/Blinds/Cars or Other Appliances with AC110~240V or DC0~28V.
You can turn on/off the receiver with transmitter (remote control) from any place within a reliable distance; the wireless RF signal can pass through walls, floors and doors.
With characteristics of reverse power protection and over current protection
Audible / visual indication
Use microcontroller model of EM78P156, an 8-bit microprocessor designed and developed with low-power and high-speed CMOS technology.
Reliable control: The transmitter (Encoding) and the receiver (Decoding) use an 8-bit code.
One/ several transmitters can control one/ several receivers simultaneously.
If you use two or more receivers in the same place, you can set them with different codes.
Transmitting Frequency: 315MHz / 433MHz
Working distance of transmitter and receiver with external extend antenna: 2000M / 6000ft (theoretically)
Model No.: S1PU-DC12-ANT2 / S1PU-DC24-ANT2
Channel: 1 CH
Control Mode: Toggle, Momentary, Latched
Coding Type: Learning code
Coding Setting: By learning
Power Supply (Operating Voltage): DC12V±1V (S1PU-DC12-ANT2), DC24V±1V (S1PU-DC24-ANT2)
Working Voltage Range of Relay: AC110~240V or DC0~28V
PCB Size: 74mm x 52mm x 24mm
Case Size: 79mm x 58mm x 35mm
Maximum Working Current: 30A
External Extend Antenna:
Frequency Range: 300~450MHz
Antenna Length: 15cm
Cable Length: 150cm
Anti-interference, waterproof, shielded wire set inside
Magnetic stand design for easy to install
Model No.: CB-2
Channel: 2 CH
Remote Control Distance: 1000m / 3000ft (theoretically)
Encode: Fixed code by Pins
Unit size: 135mm x 42mm x 25mm
Power Supply: 1 x 6F22-9V battery (Included, useful life 6-12 months)
Setting control mode Toggle: Only connect Jumper-1. Control mode Toggle: Press -> On; Press again -> Off. Press big button: Turn on the relay (connect A and B, disconnect A and C) Press big button again: Turn off the relay (disconnect A and B, connect A and C)
Setting control mode Momentary: Only connect Jumper-2. Control mode Momentary: Press and hold -> On; Release -> Off. Press and hold big button: Turn on the relay (connect A and B, disconnect A and C) Release big button: Turn off the relay (disconnect A and B, connect A and C)
Setting control mode Latched: Disconnect Jumper-1 and Jumper-2. Control mode Latched: Press -> On, other relays Off; Press another button -> Off. Press big button: Turn on the relay (connect A and B, disconnect A and C) Press small button: Turn off the relay (disconnect A and B, connect A and C)
1 x Receiver: S1PU-DC12-ANT2 / S1PU-DC24-ANT2 (1 Channel / Three Control Mode)
1 x Transmitter: CB-2
1 x User manual
The distance of 2000m is a theoretical data, it shall be operated in an open ground, no barriers, no any interference. But in the practice, it may be hindered by trees, walls or other constructions, and may be exposed to some interference by other signals. Therefore, the actual distance can not reach 2000m. It depends on the actual working environment.