Remote Control TV Sliding Panel Mechanism

The sliding panel mechanism can help the flat-panel TV blend in better with the wall surface. Instead of covering the panel with canvas artwork, the sliding panel mechanism conceals the TV with a panel that matches the existing wall surface. It offers the ultimate in look, functionality and wow factor.

One of our customers built a sliding panel mechanism to cover up the TV. It was started by an ac electric motor and he would like to add an remote to control it. We recommended him ac motor remote controller model of 0020318 (S1FC-AC220 & CV-4). It contains a remote transmitter and a receiver. Wire the electric motor to the receiver and it can be controlled by the remote transmitter.

Wiring diagram as shown below:

Connect live wire to terminal “L” and neutral wire to terminal “N”. Then connect three wires of AC motor to terminals “UP”, “COMMON” and “DOWN” respectively. He can exchange “UP” and “DOWN” wires of motor to change the rotating direction of motor.

Two control modes momentary and latching are available.

Set momentary control mode: no Jumper connect.
Press and hold button ▲ on remote or receiver: motor rotates continuously in positive direction; open the sliding panel.
Release button ▲ on remote or receiver: motor stops.

Press and hold button ▼ on remote or receiver: motor rotates continuously in reversal direction; close the sliding panel.
Release button ▼ on remote or receiver: motor stops.

Set latching control mode: connect the Jumper.
Press button ▲ on remote or receiver: motor rotates continuously in positive direction; open the sliding panel.
Press ■ on remote or receiver: motor stops.

Press button ▼ on remote or receiver: motor rotates continuously in reversal direction; close the sliding panel.
Press button ■ on remote or receiver: motor stops.

Leave a Reply

Bad Behavior has blocked 41 access attempts in the last 7 days.